Brief introduction to the products
Iron core: it chooses the high-quality cold-rolled silicon steel sheets and multi groups entire ramp lap joints, banding structure. It effectively improved the distribution of the magnetic flux density within the iron core, and it met the requirements of low loss, low noise, energy saving and environmental protection of the transformer.
Winding: it chooses the high quality non-oxygen copper materials/ high strength enamelled wire (or paper-covered wire) winding and multilayer cylinder structure, even distributing ampere turns and reasonable insulation structure. High and low voltage windings can adopt the union winding, so the efficiency is high with the coil compaction. And by optimizing and cooling, heat dissipation/ temperature rise design, turn on the winding line for banding, clamping, and by the end of the winding wood laminate compaction, in order to enhance mechanical strength and short-circuit winding capacity, to ensure safe and reliable operation of the transformer.
Body: it adopts the structure of suspended core free and spacing around the body and hanging board, so that it solved the problem of body hanging in the air and the body can’t displace, at the same time, it avoided the bad impact to the product’s quality of the bumps on the transportation; The fastener using in the body adopts the locknut which can guarantee it wont get loose on the long distance transportation. Therefore, the new product is no need for inspection before putting into operation.
Tank: to choose the structure of corrugated tank or radiator expansion tank, maintenance-free, non-leaking, small size, good heat dissipation, novel structure, while canceling the oil storage tank and the moisture absorber, the changing of oil volume is regulating by the corrugated tank plates or the flexibility of radiator expansion tank. As the temperature is raised/ reduced, the increase or decrease in the transformer insulation oil is expansion or contraction, at the same time, it separates the transformer inside with the air, the transformer insulating oil does not touch with the oxygen and water, so that it will reduce the aging speed of insulating oil and paper materials to extend the using life of the product. Besides this, the seal of the tank adopts the oil proof silica gel seal parts, it is resistant to aging and crack, so that it can be used for many years without replacement. However, the operation and maintenance of the new product is simple, it is saving the cost of maintenance of power for the customers.
Surface treatment and coatings: the spare parts and tank surface are spray painting by three anti-paints (anti-damp, anti-rot, anti-salt fog) after phosphating, to meet a variety of use of the environment and to ensure that the coating surface treatment does not fall off, no rust, the color is fresh, bright, beautiful appearance.